Imc-networks iMcV-Giga-FiberLinX-II Manual de usuario descargar pdf (Pagina 55)

Serial Port Pinout

The iMcV-Giga-FiberLinX-II features a serial port that uses an IBM-compatible DB-9

serial connector. To connect an iMcV-Giga-FiberLinX to your workstation, use a

straight-through (pin-to-pin) cable.

If your workstation has a serial port using a connection not compatible with a DB-9

COM port, use the pin connection chart for reference in making a cable.

Ensure the cable length is less than 50 ft. (15.24 m). Plug one end of the cable into

the DB-9 connector on the iMcV-Giga-FiberLinX and the other into the appropriate

port on your workstation.

Set your workstation for VT-100 emulation. The serial port on the workstation should

be set for:

Pin Configuration Chart

Pin Signal

2 Transmit (Out)

3 Transmit (In)

5 Ground

1, 4, 6-9 Reserved

•

38.4K baud

•

8 data bits

•

1 stop bit

•

no parity

•

no flow control

1 2 ... 50 51 52 53 54 55 56 57 58 59 60

Sin comentarios

Imc-networks iMcV-Giga-FiberLinX-II Manual de usuario Pagina 55