IMC Networks iMcV-T1/E1/J1-LineTerm Manual de instrucciones descargar pdf (Pagina 11)

These standard Telco transmission pattern modes are provided to help diagnose

transmission errors in the line.

By default this feature is set to Standard Data.

This feature can be controlled by SNMP-Management software (iView

) when the

HOST iMcV-T1/E1/J1-LineTerm module is installed in a managed chassis.

T1, E1 and J1 Selection

This switch selects the data rate to use on the copper line. The data rate selections

available include the following:

•

T1/J1

(1.544 Mbps +/- 32 ppm)

•

(2.048 Mbps +/- 32 ppm)

By default this feature is set to

T1.

This feature can be selected only by setting the DIP Switches manually.

Remote Management

A DIP Switch enables or disables the Remote Management mode. By default this

feature is Disabled. Remote Management must be enabled on the REMOTE

module. This allows all SNMP-configurable features for the REMOTE modules to

be configured from the HOST module.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Sin comentarios

IMC Networks iMcV-T1/E1/J1-LineTerm Manual de instrucciones Pagina 11