IMC Networks McLIM, TP-TX/SSFX-SM1550/PLUS-SC Manual de instrucciones

MediaConverter Series Operation Manual

6 LinkLoss, FiberAlert and Link Fault Pass-Through McPIM TP/FO and McLIM TX/FX and TX/SX include the following features: • FO/FX LinkLoss (a.k.a. &quo

7 Link Integrity During normal operation, link integrity pulses are transmitted by all point-to-point Ethernet devices. When an IMC Networks media co

8 Link Fault Pass Through Link Fault Pass Through (LFPT) is a troubleshooting feature that combines TX and FX LinkLoss from both the local and remote

9 Pulsing FiberAlert Pulsing FiberAlert minimizes the problems associated with the loss of one strand of fiber. If a strand is unavailable, the devic

10 Auto Negotiation The following chart states the availability of the Auto Negotiation feature on media conversion modules. Auto Negotiation Product

11 NOTE McLIM TPTX/FX is a Plug-And-Play device, therefore Auto Negotiation is always enabled. The following table states the availability of Auto neg

12 Power Supply Installation When installing a redundant power supply module into a powered-on 12-Slot chassis, IMC Networks recommends setting the ON

13 LEDs on McPIM TP/FO (-10) The LED functions on McPIM TP/FO (-10) are as follows: FO LINK/ACT Glows green when link is established on the FO port;

14 LEDs on McGigabit and McLIM TX/FX and TX/SX (-00, -10, 20, 30) The LED functions on McGigabit and McLIM TX/FX and TX/SX Modules are as follows: FX

15 Installation Troubleshooting The following information assists in troubleshooting the Modular Media Converters: • During installation, first test t

ii FCC Radio Frequency Interference Statement MediaConverter/1 and /4 This equipment has been tested and found to comply with the limits for a Class

16 Rackmount Instructions Elevated Operating Ambient If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the ra

17 Specifications Operating Temperature +32°F to +122°F (0°C to +50°C); 5% to 95% (non-condensing), 0 – 10,000 ft. altitude Storage Temperature -13°F

18 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, whi

19 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The produc

1 19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2010 IMC Networks. All r

iii Warranty IMC Networks warrants to the original end-user purchaser that this product, EXCLUSIVE OF SOFTWARE, shall be free from defects in material

iv Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

1 About the Modular Media Converters The Modular Media Converter Series includes modules that convert copper to single-mode or multi-mode fiber at Eth

2 About McLIMs McLIMs (Media Converter Link Interface Modules) are 100 Mbps Fast Ethernet modules which provide a single-conversion between 100Base-TX

3 Board Diagrams and Jumper/Switch Settings NOTE To determine which board diagram matches the module (-20, -30, -40, -50, etc.), compare the jumper

4 Media Converter Jumper/DIP Switch Configuration Table Module/Board Feature Jumper Position ON (pins) OFF (pins) Factory Default McPIM TP/FO (-20)

5 Twisted Pair Crossover/Straight-Through Connections Whether using crossover or straight-through CAT5 twisted pair cabling, all Switching Modules wil