IMC Networks 852-11913 Manual de instrucciones descargar pdf (Pagina 14)

•

Setting the LoSPd DSW to ON will force the SFP to operate at 100Mbps. When

set in the default of OFF, the SFP will run at its maximum rate of the SFP

installed. (100 or 1000 Mbps supported)

•

If a dual speed fiber SFP 100/1000Mbps is installed, setting the LoSpd to ON will

force the SFP to operate at 100Mbps

PoE Reset 1 and PoE Reset 2 DSW

When set to ON, it will force the PSE output power on the copper port OFF when

the LINK state is lost on the fiber segment. By default, the DSW is set to OFF.

PoE+ Giga-McBasic 1x9

DIP

Switch

Name Description Default

Setting

DIP Switch

PoE Reset 2 ON forces Port 2 PoE

OFF on LOS of Fiber

input

OFF

PoE Reset 1 ON forces Port 1 PoE

OFF on LOS of Fiber

input

OFF

Factory Set Do not change OFF

PoE Reset 1 and PoE Reset 2 DSW

When set to ON, it will force the PSE output power on the copper port OFF when

the LINK state is lost on the fiber segment. By default, the DSW is set to OFF.

NOTE

Under no conditions will the LoSPd DSW impact any copper SFPs. Some 1000Mbps SFPs

may not function properly when forced to 100Mbps.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sin comentarios

IMC Networks 852-11913 Manual de instrucciones Pagina 14