IMC Networks iMcV-T1/E1/J1-LineTerm TP/Fiber-CWDM-SM1310-SC Manual de instrucciones

iMcV-T1/E1/J1-LineTerm Operation Manual

7 This feature can be controlled by SNMP–Management software (iView2) when the HOST iMcV-T1/E1/J1-LineTerm module is installed in a managed chassis.

8 This feature can be controlled by SNMP-Management software (iView2) when the HOST iMcV-T1/E1/J1-LineTerm module is installed in a managed chassis.

9 LED Operation The iMcV-T1/E1/J1-LineTerm module features several diagnostic LEDs per port. The following LED display functions are provided: Copp

10 Loopback Testing The iMcV-T1/E1/J1-LineTerm includes three Loopback test modes: Copper Loopback, Fiber Loopback and Internal Fiber Loopback. The

11 CentralOfficeCustomeriMcV-T1/E1/J1-LineTermiMcV-T1/E1/J1-LineTermCopper CopperFiberXNoneCopper LoopbackCopper Loopback on Host iMcV-T1/E1/J1-LineT

12 Installation Troubleshooting General Troubleshooting • The copper port can easily be tested using the internal PRBS signal generator and detector

13 The following table lists the pin configuration for the RJ-48 connector. Pin Signal 1 Receive Ring 2 Receive Tip 3 No Connection 4 Transmit Ring

14 Specifications Standards Compliance (T1, E1, J1): ANSI T1.102-1993 ANSI T1.107.1995 GR-820-CORE T1, E1, J1 Interface: T1 (1.544 Mbps +/- 32 ppm) E

15 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, wh

16 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The products

ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class A computing device, pursu

19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2011 IMC Networks.

iii Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

1 About the iMcV-T1/E1/J1-LineTerm iMcV-T1/E1/J1-LineTerm is an SNMP-Manageable module that convert standard TDM-based copper transports ( T1, E1, J1)

2 Prerequisites The iMcV-T1/E1/J1-LineTerm conforms to any T1/E1/J1-based environment. Ensure all of the relevant information about the expected ins

3 Managed Modules The iMcV-T1/E1/J1-LineTerm modules are installed as a HOST-REMOTE pair and can be remotely managed when the HOST is installed in an

4 Unmanaged Modules Before installing the module in an unmanaged chassis, manually configure all of the desired DIP Switch selectable features. Modu

5 DIP Switch Settings (S2, S3) Switch Settings for Switch S2 T1/E1 Selection S2-1: OFF T1 Mode Selected default S2-1: ON E1 Mode Selected

6 Switch Settings for Switch S3 Reserved S3-1: ON Reserved S3-1: OFF Reserved default Remote Management S3-2: ON Remote Management